MINERAL PROCESSING EPC+M+O

Lims magnetic separators

Lims separators are designed around the revolving magnetic drum with an internally stationary magnetic array. They are available in several types for vast number of duties and could be seen as split into two categories dry separation and wet separation. The dry models are intended predominantly for material 2 to 200 millimeters in dry or nearly dry state like crushed iron ore.

Magnetic Drum Separator (Wet) Sepor Inc

Wet drum magnetic separators are used in magnetic particle recovery removing the magnetic component from a slurry and discharging the magnetic concentrate from one end and the nonmagnetic content from the tailing discharge typically located on one side of the separator. Wet drum magnetic separators are more efficient that dry drums because water makes a good medium for dispersing solids and this gives a much more consistent particle surface area to magnet surface

Wet Magnetic Drum Separator

Wet Magnetic Drum Separator Lowintensity separators are used to treat ferromagnetic materials and some highly paramagnetic minerals. Minerals with ferromagnetic properties have high susceptibility at low applied field strengths and can therefore be concentrated in low intensity (<~0.3T) magnetic separators.

Eriez Wet Drum Separators

Wet drum magnetic separators are the most vital part of the upgrading process in magnetite concentration. The upgrading of primary magnetite is always accomplished with wet drum separators. Mill feed is typically upgraded to 65+ percent magnetic iron using a series of wet drum magnetic separators.

Magnetic Separators

Eriez Permanent Magnetic Drum Separators

Eriez Magnetic Drum and Drum InHousing Separators. Eriez Drum Separators remove both large and small pieces of iron contaminants from material processing lines. Powerful permanent magnets enable more efficient separation performance for a broader range of applications than ever before.

Magnetic Separators Magnetic Drum Separators Dings

Magnetic Drum Separator. Dings Magnetic Drum Separator is a permanent selfcleaning separator designed for heavyduty highvolume ferrous recovery. Its rugged contruction is ideal for separating ferrous metal from material such as shredded cars slag crushed ore and ash at mass burn plants. ON MAGNETISM! Dings Patented FLUX CONTROL CIRCUIT provides more magnetic power See Details...

Drum Separator an overview ScienceDirect Topics

Lowintensity wet separation is widely used for recycling (and cleaning) magnetic media in dense medium separation (DMS) processes (see Chapter 11) and for the processing of ferromagnetic sands. The general design of drum separators is a rotating hollow nonmagnetic drum containing multiple stationary magnets of alternating polarity.

Wet Magnetic Drum Separator Sepor Inc

Wet drum magnetic separators are used in magnetic particle recovery removing the magnetic component from a slurry and discharging the magnetic concentrate from one end and the nonmagnetic content from the tailing discharge typically located on one side of the separator. Wet drum magnetic separators are more efficient that dry drums because water makes a good medium for dispersing solids and this gives a much more consistent particle surface area to magnet surface

Wet Drum Permanent Magnetic Separator Manufacturer

Jaykrishna Magnetics manufactures wet drum separator which is used to remove very fine magnetizable components from low concentration lowviscosity liquids. The wet drum separator is intended for use in the metal processing industry and for the treatment of preconcentrates extracted from the high gradient magnetic filter.